Edit product


Hinge Fix - Digital File for 3D Printing

NEW Update: I've made some slight changes based on feedback I've gotten to make this part just as strong but allow for more ear cup range-of-motion. What: Hinge repair bracket for AudioTechnica ATH-M50x

Why: The one obvious mechanical design flaw on these otherwise incredible headphones is the design for the plastic tab that prevents the ear cups from rotating past the point of sitting over your ears. Basically this small plastic tab is a single point of failure for holding pressure on your ears. If this breaks, your headphones are useless.

Previous options for repair were limited. You could either try gluing a new piece in place, but frankly there's just too much pressure but on this part, and it will break in short order. The other alternative was to buy a replacement headband for ~$25 usd off of ebay. This works, but swapping headbands is not easy - there's a lot of tricky disassembly, wire routing, and reassembly.

That's why I made this 3D printable solution. For just a few dollars you can get your beloved ATH-50x back in action in a few minutes.

Note: these files and the printed parts they create are for personal, non-commercial use only. By purchasing this file, you are agreeing to these terms.

Recommended Print Settings:

- Material: PLA, PETG, ABS

- Layer height: under .15mm. (My printer does a great job at 0.0875mm)

- Infill: 30%

  • You'll get files to print your own hinge fix brackets


Hinge Fix - Digital File for 3D Printing

Enter your info to complete your purchase


···· ···· ···· 4242
Test card



Use a different card?


pp paypal

or pay with

We do not keep any of your sensitive credit card information on file with us unless you ask us to after this purchase is complete.

or pay with

You'll be charged US$8.
Powered by Gumroad